Does The Autoclave Require Vacuum Extraction

The first stage of the steam pressing process in the production line of the aerated block equipment is carried out after the blank body is assembled on the parking line in front of the steam pressing kettle. Its specific operation process is as follows: open the steam pressing kettle door, connect the trolley track, after the blank body is assembled on the parking line in front of the steam pressing kettle, open the steam pressing kettle door, connect the trolley track, send the steam curing cart into the steam pressing kettle, close the steam pressing kettle door, and extract the vacuum, minutes, When the pressure inside the autoclave reaches -0.04~0.06Mpa, open the autoclave, close the autoclave door, and extract vacuum for 30 minutes. When the pressure inside the autoclave reaches, start supplying air to the autoclave, and then supply air to the autoclave to reach the maximum temperature required for curing. This process is called the heating stage, which is generally greater than the maximum temperature required for 1.5~2 protection, During the heating stage, a large amount of condensed water is discharged, and it is necessary to do a good job in recovering the condensed water. In the production line of aerated block equipment, ball mills are equipment that finely crushes raw materials throughout the entire production line. However, during our use, there may be instances of ball mills burning tiles. We know that if the ball mill burns tiles, it must stop working, and if even the raw materials cannot be processed in the entire production line of the aerated block equipment, the entire production line must also stop working. Therefore, we must know the reasons why the ball mill may burn tiles.