What Problems May Arise in The Application Of Aerated Brick Packaging Equipment? How To Solve It?

The aerated brick packaging equipment solves the problem of brick material packaging in brick factory production, saves time, improves production efficiency, and is a natural trend in industrial production mode. For brick factories, adopting this production mode may have some investment in the initial stage, but the feedback in the later stage is very obvious. Of course, any equipment will encounter one kind of problem or another in long-term application. We want to reduce the impact of various fault problems on the production and operation of brick factories. Firstly, we should pay attention to the maintenance and protection of equipment, implement strict inspection systems, and secondly, try to solve equipment fault problems as much as possible to ensure that they are resolved as soon as possible when faults occur. So, what problems may arise in the application of aerated brick packaging equipment? How to solve it?
The aerated brick packaging equipment can achieve lower labor costs and improve production efficiency through automated operations. To achieve better work, if any abnormalities are found in the equipment during work, the emergency stop button should be immediately pressed. It is prohibited to perform any other operations without pressing the emergency stop button. Secondly, the packaging of new brick factory products is mechanically automated, which can achieve palletless packaging. However, the common problem with this packaging method is the breakage of the packaging belt. This is particularly important. If the packaging belt is found to be broken, it is necessary to first check whether there are any residual belts inside the equipment. Only when it is confirmed that there are no and the indicator light for returning to the original point is on can the belt be re fed, which is a common fault encountered by many brick factories in operation.
Secondly, during the operation of the aerated brick packaging equipment in the brick factory, more attention should be paid to the spring of the packaging machine. The function of the two springs in the middle of the equipment is to control the lowering of the friction plate and the cutting knife. If there is no welding or continuous cutting during the packaging work, the spring should be adjusted downward appropriately. The function of the two springs on the right side of the packaging machine is to compress the packaging belt. If there is a belt withdrawal, these two springs should be adjusted downward appropriately. The palletless packaging of brick materials depends on the use of the packaging machine equipment, and naturally, we are more concerned about the failure of the packaging equipment in the packaging machine. Another common problem with the equipment is that the belt is not tightly tied. Therefore, it is necessary to check the broken belt detection switch first, and use your hand to hold the switch until the packaging belt is tightened before releasing it. If the belt is tightened, adjust the direction angle of the swing rod of the broken belt detection switch. If the strap is still not tight, increase the tension and retraction time appropriately. If you find that the tension of the strap is not enough during hand support, you need to adjust the two nuts on the connecting rod at the rubber wheel of the packing head downward appropriately. The firmness of packaging is related to the loading and unloading of brick stacks, transportation, product loss rate, and the safety of staff, and everyone should pay attention to it.